Installing Logs; Installing Front Log; Installing Rear And Middle Logs - Superior VD1824NR Operation Instructions Manual

INSTALLING LOGS

WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
LVD18-GO AND LVD24-GO
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place rear log onto base. Holes in bottom
of log must seat over pins on base as
shown in Figure 18.
2. Place center log onto base. Holes in bot-
tom of log must seat over pins on base
as shown in Figure 18.
Center Log
Pin for
Hole in
Bottom
of Log
Figure 18 - Installing Rear and Middle Logs
16
INSTALLATION
Continued
Rear Log
Burner
www.SuperiorFireplaces.US.com
3. Place front log onto grate as shown in
Figure 19. Front log has cut outs for the
fingers of the grate to fit into.
Front Log
Grate
Figure 19 - Installing Front Log
4. Place left crossover log as shown in Fig-
ure 20, page 17. Match square peg on top
of center log with square hole on bottom
of left crossover log. Match pin on top of
front log with round hole on bottom of left
crossover log.
5. Place center crossover log as shown in
Figure 20, page 17. Match square peg on
top of rear log with square hole on bottom
of center crossover log. Match pin on top
of center log with round hole on bottom
of center crossover log.
6. Place left front crossover log as shown in
Figure 20, page 17. Log should rest on the
grate and fit into recess area on the center
log.
126839-01A