Start Optimisation - Viessmann Vitocal 200-G Installation And Service Instructions Manual

Start optimisation

Operating instructions
Stop optimisation
Operating instructions
DHW auxiliary function
Operating instructions
Set DHW temperature 2
Operating instructions
Heat pump cylinder volume
A second (lower) cylinder temperature sensor must be installed so that the
entire volume of the connected DHW cylinder can be heated in "Standard"
mode. This cylinder temperature sensor must be activated in the control unit
using this parameter.
Note
If the cylinder temperature sensor 2 is disabled, then the control unit will only
regulate the cylinder temperature sensor 1 in the operating modes "Upper" and
"Standard".
Access
& "Device settings"
& "Programming"
& "DHW"
& "Vol. cylinder for HP"
("YES"/"NO")
DHW control settings
Standard setting
Setting range
YES
YES/NO
151