Ip Settings; Details - TANDBERG 150 MXP Administrator's Manual

IP Settings

IP-address.
IP-address defines the network
address of the codec. This address is used in
static mode only. In DHCP-mode, the assigned IP-
address can be found on the Welcome Menu.
IP-subnet mask. IP-subnet mask defines the type
of network. This address is only used in static
mode. Your LAN administrator will provide the
correct value for this field.
Gateway. When using DHCP , the default gateway
will be set automatically. If the LAN utilises static
IP addresses, IP address, subnet mask, and
default gateway must be specified by the LAN
administrator.
IP Access Password.
By setting an IP Access
Password on the system, all access to the
system using IP (Telnet, FTP and WEB) requires
a password. The default IP Access Password is
TANDBERG.
OK
Select this icon and press to leave the
menu putting changes into effect.
Save and Restart.
Select this icon and press
OK
to restart the system putting changes into
effect.
OK
Select this icon and press to restore the
default settings.
OK
Select this icon and press to leave the
menu undoing any changes.
The system will need to be restarted
after making changes to IP Settings. This
Save and
can be done by selecting the
Restart . Changes in IP Settings menu will not
have any effect until the system is restarted.
Table of Trademarks & Patents &
Contents Copyright Disclaimers
D 14127.01
01.2008
IP Settings Details
About
Safety/ To Get You
Administrator
Environmental Up and Going
Settings
General Audio
Settings Settings
38
TANDBERG 150
ADMINISTRATOR'S GUIDE
ADMINISTRATOR'S GUIDE
IPv4. IP version 4 supported.
IPv6.
IP version 6 supported. IP Address, IP
Subnet Mask and Gateway will be disabled.
Both.
Both IP version 4 and IP version 6
supported.
IP-assignment
DHCP
(Dynamic Host Configuration Protocol) can be
selected when a DHCP server is present.
For IPv6 , DHCP is used for NTP / DNS Server
Addresses. DHCP IP-address, IP-subnet mask and
Gateway are not used because the DHCP server
assigns these parameters.
Static The system's IP-address, IP-subnet mask and
Gateway must be specified in the IPaddress field.
Ethernet Speed
Auto
The system will auto-detect the speed/
duplex on the LAN.
10/Half The system will connect to the LAN
using 10Mbps speed/Half Duplex.
10/Full 10 Mbps speed/Full Duplex.
100/Half
100 Mbps speed/Half Duplex.
100/Full
100 Mbps speed/Full Duplex.
DNS Server 1-5.
DNS Server defines the network
addresses for DNS servers. Up to 5 addresses may
be specified. If the network addresses are unknown,
please contact your administrator or Internet ervice
Provider.
DNS Domain Name. DNS Domain Name is the
default domain name suffix which is added to
unqualified names.
DNS Domain Name is example.com,
Example:
and the name to lookup is videosystem will result
in a videosystem.example.com DNS lookup.
Security Network Network
Profiles &
Settings Settings Settings
Wizard
MXP
TANDBERG 150MXP
Diagnostics
Reset &
Upgrade