AKG AV100 Manual page 28

Aviation headset
Table of Contents

Advertisement

Troubleshooting
Problem
Intercom is hardly audible
Intercom can be only heard in
one ear
Bluetooth audio or AUX audio is
not audible
The headset powers down
after some minutes
I can't be heard when I make a
call via Bluetooth
If the error persists despite these instructions, contact AKG Acoustics GmbH or your AKG dealer
immediately.
28
Possible cause
Aircraft panel audio output too low.
Misbalance between the different
in Audio sources.
Dashboard only provides a Mono
signal
Source priority slide switch is
switched to OFF
Left and right volume wheels (3, 4)
are turned to minimum
The batteries are getting empty
The microphone is not connected
to the dashboard or the dashboard
is not powered up
The microphone is not connected
to the dashboard or the dashboard
is not powered up
Remedy
Adjust the volume form your
aircraft panel 1
while the volume
st
wheels (3, 4) are turned half way
up. Then subsequently raise the
volume on your paired Bluetooth
device or the device connected to
the AUX input.
Switch the Mono/Stereo Switch
(14) on the control unit to position
"Mono"
Switch the Source priority slide
switch to AUTO or MIX
Turn up the volume wheels
Replace the batteries
Plug the microphone in the
(powered up) dashboard
Plug the microphone in the
(powered up) dashboard
Aviation Headset AV100

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents