Lexmark W812 Service Manual page 97

4022-XXX
Top-level Menu
Input Tray Tests
BASE SENSOR TEST
DEVICE TESTS
Only displayed if a flash or disk unit is installed.
PRINTER SETUP
Intermediate Menu,
Printer Setting, or
Operation
Feed Test
For additional
information, go to "Base
Sensor Test" on
page 3-14.
Quick Disk Test
Only displayed when a
disk is installed.
Disk Test/Clean
Only displayed when a
disk is installed.
Flash Test
Only displayed when an
optional flash memory is
installed which is not
defective.
Defaults
Page Count
Perm Page Count
Serial Number
Configuration ID
Edge to Edge
Par S Strobe Adj
Only displayed if the
printer is configured with a
standard parallel port.
Value List
Only installed paper sources are
displayed.
Tray 1
Tray 2
Tray 3
MP Feeder
Single
Continuous
For additional information, go to
"Input Tray Feed Test" on
page 3-13.
Go to "Quick Disk Test" on
page 3-15.
Go to "Disk Test/Clean" on
page 3-15.
Go to "Flash Test" on
page 3-16.
U.S.*
Non-U.S.
0 to 9999999 (0)
0 to 9999999 (0)
xxxxxxxx (printer serial number)
where x = A - Z, 0 - 9, '-' or ''
000000 to 999999
Off*
On
-4 to 6 (0)
Diagnostic Aids
3-3