Lexmark W812 Service Manual page 61

4022-XXX
User Error Message
39 Complex Page
4<x> Unsupported Firmware
Card
50 PPDS Font Error
51 Defective Flash
52 Flash Full
53 Unformatted Flash
54 Serial Option <x> Error
54 Standard Serial Error
54 Network <x> Software Error
54 Std Network Software Error
Explanation
The page may not print correctly because the print
information on the page is too complex. Press Go to
clear the message and continue printing the job. The job
may not print correctly. Press Menu to open the Job
Menu and cancel the current job. To avoid this error in
the future:
•
Reduce the complexity of the page by reducing the
amount of text or graphics on the page and deleting
unnecessary downloaded fonts or macros.
•
Set Page Protect to On in the Setup Menu.
•
Install additional printer memory.
The printer detects an unsupported version of firmware
on the installed firmware card. Turn the printer off, and
then press and hold Go while turning it on. The printer
reads the code on the RIP Controller card and bypasses
the code on the firmware card. Remove the firmware
card if problem persists.
The printer cannot find a selected PPDS font and the
Best Fit setting is turned off. Press Go to clear the
message and continue processing the job. Press Menu
and select Cancel Job from the Job Menu. Press Menu
ad select Reset Printer from the Job Menu.
The printer detects defective flash memory. Press Go to
clear the message and continue printing. You must
install different flash memory before you can download
any resources to flash.
There is not enough free space in the flash memory to
store the data you are trying to download. Press Go to
clear the message and continue printing. Download
fonts and macros not previously stored in flash memory
are deleted. Deleted fonts, macros, and other data
stored on the flash memory. Install flash memory with
more storage capacity if needed.
The printer detects unformatted flash memory. Press Go
to clear the message and continue printing. You must
format the flash memory before you can store any
resources on it. If the error message remains, the flash
memory may be defective and require replacing.
The printer has detected a serial interface error on a
serial port. Make sure the serial link is set up correctly
and you are using the appropriate cable. Press Go to
clear the message and continue printing. The job may
not print correctly. Press Menu to open the Job Menu
and reset the printer.
The printer cannot establish communications with the
installed network port. Press Go to clear the message
and continue printing. The job may not print correctly.
Program new firmware for the network interface by way
of the parallel port. Press Menu to open the Job Menu
and reset the printer.
Diagnostic Information
2-5