Glass Pack; Hinge; Hydraulic Hinge - Wolf Wall Oven-2 Series Technical & Service Manual

Component Access & Removal
Glass Pack Removal
NOTE: There are different screws sizes. Make sure
the proper length screws are in the correct places when
reassembling.
To begin, remove oven door assembly and outer door
skin assembly. Now, extract the screw at the bottom
center of the door liner. Next, extract the seven screws
at the top of the heat shield and remove. (See Figure
4-39). Now, carefully remove insulation from around
glass pack. Then, extract the screws from the top of
the inner heat shield and remove. (See Figure 4-40).
Now, lift the top of the glass pack up slightly while
pulling it out from under the bottom tabs and remove.
(See Figure 4-41).
When removing or disconnecting the door hinge,
remember it could recoil quickly when released.
Hinge Removal
To begin, remove the oven door assembly and outer
door skin assembly. Next, extract the two screws at the
bottom corner of the door liner. (See Figure 4-42).
Raise the bottom of the door hinge assembly from the
door liner. Then, using a small flat bladed screwdriver,
carefully raise the tab at the top of the hinge and slide
the hinge out from under tab and remove. (See Figure
4-43).
Hydraulic Hinge Removal
To begin, remove the oven door assembly and outer
door skin assembly. Next, extract the two screws at the
bottom corner of the door liner. (See Figure 4-42).
Now, raise the bottom of the hydraulic hinge assembly
from the door liner. Then, using a small flat bladed
screwdriver carefully raise the tab at the top of the
hydraulic hinge and slide the hinge out from under tab
and remove. (See Figure 4-43).
Figure 4-39. Extracting Screws from Heat Shield.
W W a a l l l l O O v v e e n n S S e e r r i i e e s s
W W a a l l l l O O v v e e n n S S e e r r i i e e s s
Figure 4-40. Removing Inner Heat Shield.
Figure 4-41. Removing Glass Pack Assembly.
Figure 4-42. Extracting Screws for Hinge Removal.
Figure 4-43. Raising Tab for Hinge Removal.
4-14