Wolf Wall Oven-2 Series Technical & Service Manual page 48

Component Access & Removal
COMPONENT ACCESS AND REMOVAL
This section explains how to access and remove components from a Wolf wall oven. Depending on which compo-
nent you are going to access or remove in the following sections, you may have to remove other components first.
Refer to the appropriate section in this manual that explains how to access and remove those various components.
When reassembling, just reverse the steps that were used to access and remove the components.
NOTE: Before attempting to access or remove any components from a Wolf appliance, take note of the WARN-
INGS and CAUTIONS below.
TO AVOID ELECTRIC SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER SERVICING
AND/OR ACCESSING COMPONENTS.
KEEP IN MIND THAT OVEN SURFACES AND COMPONENTS GET HOT DURING USE OF THE APPLIANCE.
IF IT IS NECESSARY TO REMOVE A UNIT FROM ITS INSTALLATION, REMEMBER THAT THE UNIT COULD
TIP FORWARD WHEN PULLED BEYOND ITS INSTALLATION, RESULTING IN SERIOUS INJURY OR DEATH.
PULLING A UNIT FROM ITS INSTALLATION SHOULD ONLY BE PERFORMED BY AN AUTHORIZED SERVICE
TECHNICIAN OR INSTALLER.
When working on the oven and components, be careful when handling sheet metal parts. There may be
sharp edges present.
If removing or disconnecting the door hinges, remember it could recoil quickly when released.
W W a a l l l l O O v v e e n n S S e e r r i i e e s s
W W a a l l l l O O v v e e n n S S e e r r i i e e s s
4-2