Disc Control Features Playing Cds; Playing Other Disc Mode - Kenwood KDC-PS909 Instruction Manual

Disc control features
Playing CDs
Playing CDs:
Press the ¡(EJECT) button to slide open the faceplate,
showing the CD (insertion) slot. Holding the CD with the
labeled side facing up, insert it in the slot. The faceplate will
show the control panel, and the CD will start playing.
The ¢ indicator will light when a CD has been inserted.
Playing CDs Already Inserted:
Press the SRC button repeatedly until the CD mode is
obtained. "CD" is displayed when the CD mode has been
selected.
The CD will start playing.
Pausing and Restarting CD Play:
Press the 38 button to make the disc pause.
Press the same button again to start play again.
Eject:
Hold down the ¡(EJECT) button for one second or more to
stop CD play. The faceplate will slide to eject the CD.
Press the ¡(EJECT) button to show the control panel.
2CAUTION
• Do not attempt to insert a CD into the slot if another one is
already there.
• The unit can only play 12-cm (5-inch) CDs. If you insert an 8-cm
(3-inch) CD, it will get stuck inside and can cause the unit to
malfunction.
NOTE
• The sound will be temporarily muted whilst the faceplate is
moving.
• The only buttons that will work during the eject state are the
¡(EJECT), SRC and ATT buttons, as well as the volume
control button.
• When you load a CD and eject it right away, the next time you
try to insert the CD may not load. In such a situation, take the
CD out for a moment and then reinsert it.
(See page 7)
When the disc changer with the O-N selection switch is
connected, set the switch to "O" position to operate the disc
changer mode.

Playing other Disc mode

This function permits the connection of optional players and
the playing of discs other than the loaded CD (in the current
unit).
Playing Discs:
Press the SRC button repeatedly until the disc control mode is
obtained.
The disc will start playing.
NOTE
The disc control mode will differ, depending on the unit that is
connected.
Mode Display Examples
• "DISC"...when a disc changer is connected
• "DISC-1", "DISC-2"...when two disc changers are connected
Pausing and Restarting Disc Play:
Press the 38 button to make the disc pause.
Press the same button again to start play again.
NOTE
• When one disc has finished playing its last track, the next disc
in the changer starts playing. When the last disc in the changer
has finished, the player returns to the first disc and starts
playing it.
• Disc #10 is displayed as "0".
— 19 —