Presetting Disc Names - Kenwood KDC-PS909 Instruction Manual

Presetting Disc Names

Store the names of discs to be displayed when played.
1
Play the disc whose name you want to preset.
NOTE
• This function is not available for disc changers that do not
feature the Disc Name Preset function.
• This procedure is not to be used to store the disc and track
titles for MDs that you record.
2
Hold down the NAME.S button for two seconds or more.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
3
Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the 4
or ¢ buttons, respectively, on the remote control.
+ –
4
Press the DISC or DISC
character.
Besides the alphabet (capital letters only) and numerals, you
can choose the following characters: /,
NOTE
Direct Alphabet Input (Function of the KCA-R6A : Optional)
If the disc changers that were manufactured and sold after 1997
are connected, you can directly input letters using the
number/letter entry buttons on the remote control.
Example: Use the following table to enter the name "DANCE".
Character Button to press
"D" #3
"A" #2
"N" #6
"C" #2
"E" #3
button to display the desired
+ –
, , *, =, <, >, [ and ].
# Times pressed
1
1
2
3
2
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
6
Press the NAME.S button.
The disc name is stored and the disc name preset mode is
cancelled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
NOTE
• The number of characters and discs whose names can be
stored will differ depending on the disc changer that is
connected. Please see your disc changer manual for details.
Up to 12 characters and 100 CDs can be registered with this
unit.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the reset button erases the disc names stored in this
unit, but does not erase the names stored in a disc changer.
— 23 —