Audio Setup; Speaker Setting - Kenwood KDC-BT8041U Instruction Manual

Audio Setup

You can set Sound system , such as follows;
Adjustment Item Display
Front High Pass Filter "HPF-F"
Rear High Pass Filter "HPF-R"
Low Pass Filter "LPF"
Subwoofer Phase "SW PHASE"
Volume offset "VOL-OFFSET"
Loudness "LOUD"
Dual Zone System "2 ZONE"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "Zone2" of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 22) or [5]/[∞] button on the remote control
(page 30).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
5
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
Range
Through/40/ 60/80/100/120
/150/180/220 Hz
Through/40/ 60/80/100/120
/150/180/220 Hz
50/60/80/100/120/Through
Hz
Reverse (180°)/ Normal (0°)
–8 — ±0 (AUX: -8— +8)
OFF/ON
OFF/ON

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
1
Enter Standby
Select the "STANDBY" display.
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Speaker Setting mode
Press the [AUD] knob.
"SP SEL" is displayed.
3
Select the Speaker type
Turn the [AUD] knob.
4
Exit Speaker Setting mode
Press the [AUD] knob.
Display
"OFF"
"5/4inch"
"6x9/6inch"
"O.E.M. "
English
|
23