Function Control - Kenwood KDC-BT8041U Instruction Manual

Function Control

Functions in the table below can be set up by using Function Control.
Category Item Setting
MENU "Security Set"
"SRC Select" "1"*/ "2"
"iPod Mode" "OFF"/ "ON"*
"Device Regist"
"SPCL DVC
Select"
"Phone
Selection"
"Audio
Selection"
"Device Delete"
"BT DVC Status"
"PIN Code Edit"
"Auto Answer" "OFF"/ "0s" – "8s"*
– "99s"
"SP Select" "Front"*/ "F-R"/
"F-L"
"Call Beep" "ON"*/ "OFF"
"BT F/W
Update"
"Beep" "OFF"/ "ON"*
"Clock Adjust"
"Date Adjust"
"Date Mode" 7 types
"SYNC" "OFF"/ "ON"*
"Display" "OFF"/ "ON"*
"Dimmer" "OFF"/ "ON"*
"ILM Dimmer" "AUTO"*/ "MNAL1"/
"MNAL2"/ "OFF"
"ILM Effect" "OFF"/ "ON"*
"ILM MSC "OFF"*/ "ON"
SYNC"
"SWPRE" "Rear"*/ "Sub-W"
"AMP" "OFF"/ "ON"*
"Zone2" "Rear"*/ "Front"
"Supreme" "OFF"/ "ON"*
"News" "OFF"*/ "00min"
– "90min"
"Local Seek" "OFF"*/ "ON"
"Seek Mode" "Auto1"*/ "Auto2"/
"Manual"
"AF" "OFF"/ "ON"*
6
| KDC-BT8041U/ KDC-BT8141U
Entry Setting overview
1 sec.
Sets security code
Sets the source selection method.
When set to "ON", allows you to select music in the manner
similar to that of the iPod.
1 sec.
Register a Bluetooth device (pairing).
1 sec.
Allow registration of a special device that cannot be
registered normally.
1 sec.
Select a cell-phone subject to hands-free connection.
1 sec.
Select the Bluetooth audio player to be connected.
1 sec.
Cancel registration of the Bluetooth device.
1 sec.
Display the status of the Bluetooth device.
1 sec.
Specify the PIN code required when registering this unit
using the Bluetooth device.
Answer a call automatically after lapse of the preset time
interval for automatic answer.
Specify the voice output speaker.
Output a beep from the speaker when a call comes in.
1 sec.
Display the firmware version and update the firmware.
Setting the operation check sound (beep sound) ON/OFF.
1 sec.
Sets the clock.
1 sec.
Sets the date.
1 sec.
Sets the date display mode.
Synchronizing the RDS station time data and this unit's clock.
Turns off the display when no operation is performed.
Dims the display part in conjunction with the light switch of
the vehicle.
Sets whether the key illumination is dimmed in conjunction
with the light switch of the vehicle or it is dimmed constantly.
Sets whether the key illumination brightness is changed in
conjunction with the key operation.
Sets whether the key illumination brightness is changed in
conjunction with the sound volume.
Sets the preout output.
Turns on/off the built-in amplifier.
Specifies the destination of AUX input sound when the Dual
Zone function is turned on.
Turns ON/OFF the Supreme function.
Turns ON/OFF the News Bulletin Automatic Reception
function and sets the news bulletin interrupt disabled time.
Only stations whose reception is good are searched in auto
seek tuning.
Selects the tuning mode of the radio.
When station reception is poor, automatically switches to the
station that is broadcasting the same program over the same
RDS network.
Condition Page
20
34
12
25
25
27
— 27
27
— 34
26
34
34
34
27
21
21
— 34
34
—
34
34
34
34
34
34
35