Connecting Wires To Terminals - Kenwood KDC-BT8041U Instruction Manual

Connecting Wires to Terminals

To USB device
USB connector (1m)
REMO.CONT
Steering remote control (Light Blue/Yellow)
KDC-BT8141U only
To use the steering wheel remote control
feature, you need to an exclusive remote
adapter (not supplied) matches your car
is required.
To External Display/ Steering
remote
KDC-BT8041U only
Fuse (10A)
Wiring harness
(Accessory1)
Mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/ Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
⁄
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
8 6 4 2
7 5 3 1
8 6 4 2
Connector B
7 5 3 1
⁄
Do not remove the cap when you do not use the USB cable. The connector
will cause the unit to malfunction if it gets in touch with any metallic part of
the vehicle.
FM/AM antenna input (JASO)
AUX
AUX input (Stereo)
Use the mini-plug which is stereo type and does not have any resistance.
MUTE
P.CONT
ANT.CONT
See next page.
Microphone Unit
(Accessory 3) (3 m)
Front output
L R
Rear output/ Sub Woofer output
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
English
37
|