Central Pneumatic Contractor 98464 Set Up And Operating Instructions Manual page 16

maintenance (For All Nailers)
1. Daily - Air Supply Maintenance:
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers' instructions.
The lubricator's oil level needs to be
maintained and the moisture filter
must be regularly drained. Perform-
ing routine maintenance on the air
supply will allow the tool to operate
more safely and will also reduce wear
on the tool.
2. Quarterly (every 3 months) - Tool Dis-
assembly, Cleaning, and Inspection:
Have the internal mechanism
cleaned, inspected, and lubricated by
a qualified technician. If the vanes
need replacement, all vanes should
be replaced as a set.
3. Inspect the air supply Screen that is
located in the End Cap before each
use, and clean or replace as neces-
sary. Dirt and water in the air supply
Screen are major causes of pneu-
matic tool wear. Use a filter in the
compressed air system for better
performance and longer tool life. The
filter must have adequate flow capac-
ity for the specific application.
4. Inspect all of the nuts and screws and
make sure they are securely fas-
tened.
5. Periodically lubricate the Nailer's driv-
ing mechanism and magazine with
a light oil. Wipe down with a clean
cloth. Never use gasoline or flam-
mable solvents to clean the tool.
6. Clean the external parts of the Nailer
with a clean cloth and mild detergent
or non-flammable solvent. Then, dry.
SKU 98464 For technical questions, please call 1-800-444-3353.
7. Store Nailer in a clean, dry, safe loca-
tion out of reach of children.
loss, the Nailer/Stapler skips driv-
ing, drives too deep, or not deep
enough, take the Nailer/Stapler to a
qualified service technician.
Please refer to the Troubleshoot-
ing chart on the next page for ad-
ditional maintenance procedures.
If you detect any
air leaks, power
Page 16