Table of Contents
Advertisement
Quick Links
2 in 1 Flooring Cleat/
Staple nailer
aSSeMBlY and operating
read this material before using this product.
Failure to do so can result in serious injury.
SaVe tHiS ManUal.
©
Copyright
2006 by Harbor Freight Tools
contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight
Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual
product may differ slightly from the product described herein. Tools required for assembly and service may not
be included.
For technical questions or replacement parts, please call 1-800-444-3353.
inStrUCtionS
distributed exclusively by Harbor Freight tools
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
®
. All rights reserved. No portion of this manual or any artwork
94446
®
.
Advertisement
Table of Contents
Related Manuals for Central Pneumatic 94446
Summary of Contents for Central Pneumatic 94446
- Page 1 Tools required for assembly and service may not be included. For technical questions or replacement parts, please call 1-800-444-3353. 94446 inStrUCtionS ® . All rights reserved. No portion of this manual or any artwork...
-
Page 2: Specifications
Wear an ANSI-approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. SKU 94446 For technical questions, please call 1-800-444-3353. Specifications 1/4”- 18 NPT... - Page 3 SKU 94446 For technical questions, please call 1-800-444-3353. . Keep tools clean for better and safer performance. Follow .
- Page 4 Set the air pressure on your compressor to between 60-125 PSI. Do not exceed the maximum air pressure of 125 PSI. Check the air connection for leaks. Disconnect from the air source. SKU 94446 For technical questions, please call 1-800-444-3353. Unpacking Setup 1/4”-18 NPT...
-
Page 5: Loading The Tool
Staples – Place the staples over the center rail of the magazine. note: Only use the fastener types and sizes listed on the Specifications Chart on page 2. While holding the Sleeve (78) securely, slide the Magazine Cover (72) closed. SKU 94446 For technical questions, please call 1-800-444-3353. loading the tool... -
Page 6: Operation
Stapler. After the air compressor hose is disconnected, always fire the Stapler into a piece of scrap to make sure all of the air is expended. SKU 94446 For technical questions, please call 1-800-444-3353. operation... -
Page 7: Clearing Jams
Press the tip of the Stapler against an appropriate piece of scrap wood. Test fire the Stapler several times, checking for proper operation. Disconnect the Stapler, remove the Fasteners, and store the Stapler in a location out of children’s reach. SKU 94446 For technical questions, please call 1-800-444-3353. Clearing Jams driver... -
Page 8: Maintenance
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 94446 For technical questions, please call 1-800-444-3353. Maintenance... -
Page 9: Parts List
O-ring 21 x 2 O-ring 14.3 x 2.5 Body Cylinder O-ring 17.5 x 2.6 O-ring 38.5 x 4.5 Poppet Piston Assembly O-ring 58.7 x 3.5 SKU 94446 For technical questions, please call 1-800-444-3353. parts list part description Bumper Seal Handle A Locknut... -
Page 10: Assembly Diagram
SKU 94446 For technical questions, please call 1-800-444-3353. Page 10... -
Page 11: Limited 1-Year Warranty
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 SKU 94446 For technical questions, please call 1-800-444-3353. REV 09f...