Central Pneumatic Contractor 98464 Set Up And Operating Instructions Manual page 15

FROm ACCIdENTAL
OPERATION:
Release trigger, detach the air
supply, and safely discharge
any residual air pressure in
the tool before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOuS
INjuRY FROm TOOL
FAILuRE:
do not use damaged
equipment. If abnormal noise,
vibration, or any leakage is
detected, have the problem
corrected before further use.
Cleaning, maintenance, and
Lubrication
Anytime any maintenance or re-
pairs are done (including clear-
ing jams), FIRST:
1. Disconnect the Nailer/Stapler from the
air hose.
2. Empty Magazine completely.
3. Attempt to fire the Nailer/Stapler into a
piece of scrap wood to ensure that it is
disconnected and is incapable of firing
any staples.
4. Always leave magazine open dur-
ing maintenance. The magazine
is spring-loaded and may cause
parts or a fastener to fly out of the
Nailer/Stapler.
SKU 98464
TO PREVENT
SERIOuS INjuRY
For technical questions, please call 1-800-444-3353.
Clearing jams for 97526 Pin Nailer
1. ALWAYS wear
ANSI-approved impact safety
goggles when clearing jams.
2. In case of a fastener jam, take your
finger off the Trigger (27). Rotate the
Trigger Lock/Safety (60) clockwise
or counter-clockwise. For instance,
a "6 o-clock" position will lock the
Trigger (27) and the tool will not fire.
However, "3 o-clock" and "9 o-clock"
positions unlock the Trigger (27),
allowing the tool to fire.
Note: There is no contact safety for
the Trigger (27). When the Trigger
Lock/Safety (60) is disengaged, the
Nailer will fire.
3. Turn off the air supply and
disconnect the Nailer from the
regulator. Open the Nozzle (40) and
clear the jammed fasteners with a
pair of pliers (not included).
If a jam occurs inside the magazine,
depress the upper tip of the Click
Lever (59). The Side Cover (34)
will pop open. If needed, open the
Nozzle (40) to help clear the jam.
Once the jam is cleared, push the
Side Cover (34) back into place and
latch tight using the Click Lever (59).
Page 15