Oven Light Assembly; Front Side Trim; Convection Element; Convection Assembly - Maytag AGS1740BD series Service

Disassembly Procedures

Oven Light Assembly

NOTE: Requires removal of unit from cabinet to replace
oven light socket.
1. Turn off power to unit.
2. Open oven door to gain access to oven light.
3. Unscrew (counterclockwise) glass knurled dome.
4. Unscrew (counterclockwise) oven light bulb.
NOTE: To avoid damaging the new bulb and
decreasing life of the bulb, do not touch new
bulb with bare hands or fingers.
Hold with a cloth or paper towel.
NOTE: Proceed with the following steps for oven light
socket removal.
5. Remove unit from cutout, see "Removing and
Replacing Unit" procedure.
6. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
7. Remove screws securing outer wrapper back cover
and remove.
8. Carefully displace fiberglass insulation away from
rear of light socket.
9. Push inner assembly of light socket towards rear of
range, or twist out, depending on style of base.
10.Disconnect wires from light socket.
11. Reverse procedure to reinstall light socket.
Reposition insulation around lamp socket. Do not
overtighten.
NOTE: Reposition fiberglass insulation around oven
light socket to eliminate possibility of heat
related problems.
40 Watt, 120 Volt A-15 shape oven light bulb
Maytag Part # 7407P103-60

Front Side Trim

1. Remove power from unit.
2. Slide unit out far enough to access side trim.
3. Remove screws securing front side trim piece(s) to
oven chassis (left and right trim pieces).
4. Gently grasp trim piece with both hands, pull forward
and roll trim piece off retainer clips.
5. Reverse procedure to reinstall front side trim piece(s).
©2005 Maytag Services
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing.

Convection Element

1. Remove power from unit.
2. Remove screws securing convection motor cover to
oven chassis (screws at 12, 4 & 8 o'clock positions).
3. Remove screws securing convect element.
4. Gently slide convection element into oven cavity.
5. Label and disconnect electrical connection.
6. Replace and reverse procedure to reinstall element.

Convection Assembly

1. Remove power from unit.
2. Remove screws securing convection motor cover to
oven chassis (screws at 12, 4 & 8 o'clock positions).
3. Remove convection element, see "Convection
Element" procedure.
4. Remove screws securing convect motor to chassis.
5. Gently slide convection motor into oven cavity.
6. Label and disconnect electrical connection.
7. Replace and reverse procedure to reinstall motor.

Oven Sensor

1. Remove power from unit.
2. Open oven door and remove screws securing sensor
to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3. Disconnect oven sensor at the connector terminal
and remove.
4. Reverse procedure to reinstall sensor.
NOTE: Verify sensor wires are pushed through the
insulation.
16026293
Oven Sensor
Cooling
Fan
Spark
Module
29