Oven Light; Troubleshooting - Maytag MER8700DB User Instructions

Table of Contents

Advertisement

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Oven will not operate
Oven temperature too high or
too low
Oven indicator lights flash
Display shows messages
Clean cycle did not work on all
spills
14

Oven Light

TROUBLESHOOTING

to possibly avoid the cost of a service call.
www.maytag.com
POSSIBLE CAUSES
Power supply cord is unplugged.
ENERGY SAVE is active, and the
display is blank.
Household fuse is blown, or a
circuit breaker is tripped.
The control displays an F9 or F9
E0 error code.
The control knob is not set
correctly.
On ceramic glass models, the
oven control lockout is set.
Cookware is not the proper size.
Control knob set to incorrect heat
level
Range is not level.
Delay start is set.
Control lock is on.
Control is in Demo Mode.
Electronic oven control set
incorrectly
Oven temperature needs
adjustment.
Power to range is turned on or
restored.
Power failure (display shows
flashing time)
Error code (display shows letter
followed by number)
Start needs to be pressed so a
cycle can begin (display shows
"PUSH" or "PSH").
Several cooking cycles between
Clean cycles or spills on oven
walls and doors.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
SOLUTIONS
Plug into a grounded outlet.
Press any key on the control to display the Time of Day. See the
"Electronic Oven Controls" section for more information.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
The electrical outlet in the home may be miswired. Contact a
qualified electrician to verify the electrical supply.
Push in knob before turning to a setting.
See the control lock keypad feature in the "Feature Guide"
section.
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ¹⁄₂" (1.3 cm) outside the cooking area.
See "Cooktop Use" section.
Level the range. See the Installation Instructions.
See "Timed Cooking" section.
Press and hold START for 3 seconds to unlock.
Press and hold DELAY START for 10 seconds.
See "Electronic Oven Controls" section.
See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator lights keep flashing, call for service. See
cover for contact information.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Depending on your model, press CANCEL to clear the display.
See "Control Display" in the "Electronic Oven Controls"
section. If it reappears, call for service. See cover for contact
information.
See the "Start" keypad feature in the "Feature Guide" section.
Run additional Clean cycles. Use the AquaLift
Cleaning Kit. Use affresh
affresh
®
Cooktop Cleaner. See the "Accessories" section for
more information.
®
Technology
®
Kitchen and Appliance Cleaner or

Advertisement

Table of Contents
loading

Table of Contents