Table of Contents
Advertisement
This page shows the charging process with parameters and graph.
Voltage and current will reach to the preset parameters. The preset
current might have limitation depending on charge/discharge capacity
and input voltage setup. Max charge is 400W and max discharging
is 60W
When to tap graph, the data view page is accessed.
The operating data is shown.
Please refer page (27~29 page)
When to tap the part in red circle, Set current window appears and
you may change the charge current during operating and set current
window disappears when to tap X button.
This setup is applied to the charger that is charging and it is not
stored to memory
When to STOP button, the pop up window appears which asks
whether to stop operating. When to tap STOP or ESC button, the
charger will stop or continue the charge
19
◎ DISCHARGE PAGE
When to tap DISCHARGE icon on main page, you may access to discharge mode. The program-
ming setup and page transition is the same with CHARGE mode
USER NAME
This page shows discharge setup when to select
LiPo, Lilon, LiFe, NiCd, NiMH, Pb batteries
When to tap the part in red circle, it is activated in
blue and the parameters can be programmed
LiPo, LiIon, LiFe, NiCd, NiMH, Pb battery discharge mode
- Voltage
: Final discharge voltage for each cell can be programmed
- Current
: Discharge current, this can be adjusted from 0.1 to 10 Amps and operated within max 60W
- Cut-Temp
: Cut off temperature. When used with the optional temperature sensor, a safety cut-off tem
perature can be set, so that charging or discharging is terminated automatically if the
temperature sensor detects the battery temperature rising above the preset temperature.
- Max Capacity
: The maximum capacity setting is used to terminate a charge if the charger exceeds
the preset percentage of the battery capacity since the batteries that are decrepit or
in bad balancing or programmed improper parameters can be over discharged
Tap DISCHARGE icon to discharge at
main page
20
Advertisement
Table of Contents
