Table of Contents
Advertisement
◎ MISE PAGE (Addition function)
When to tap MISE icon on main page, you may access to MISE mode and program Servo,
Brushless/Brushed power motor, Warmer function.
USER NAME
You may use the additional function at CH1
or CH2, which is not operated.
This is MISE setup page.
When to tap 3 icons, each mode can be accessed and tap ESC
button to get back to the previous page at each mode
Servo and Brushless motor testing setup
Mid signal
Min signal
Output Signal
Motor RPM
Output voltage
Stop
31
Tap MISE icon to program MISE setup at
main page
- It is used to test Servo and Brushless Motor
- It is used to test and tame Brushed Motor
- It is used to warm up battery and tire
Sensor check
Max signal
Auto loop time
Output current
Kv data
Start
1) Servo test division (Screen top)
- Connect Servo to the connecter in the right side of charger, refer below picture
Check the servo connector
polarity S,+,-
Min, Mid, Max signal
: When to tap the relevant buttons, servo is operated in accordance with the preset
signal. The parameters of each article can be changed tapping DEC/INC buttons
Output signal
: It shows the current signal output parameters
Auto loop time
: When to tap Enter button after setting 0.1~5.0sec, Auto loop is operated.
The high power servo may not be operated smoothly in the short operating
time since it needs much more peak current. In this case, extend the
operating time
2) Motor test division (Screen Top and bottom)
- Motor sensor connector and servo test connector are used
Sensors on the top shows whether 3 sensors in the motor is OK or not
RPM and Kv are shown in the bottom
Rotate the motor shaft for about 5 seconds continuously,
then the charger shows whether sensor is OK or not.
Motor should be connected to motor sensor connector
To check motor RPM and Kv, the optional splitter is
needed , refer below picture
32
Advertisement
Table of Contents
