Operating The Boiler - Baxi Combi 130 HE User Operating Instructions Manual

Lower Door Panel
Burner ON Indicator
(Orange Light)
LCD Display
o C
Reset
On/Off Reset
Temperature
Control Buttons
Fig. 2
On/Off Reset
Fig. 2a
4
Fig. 1
Flame Failure Indicator
(Red Light)
Pressure Gauge
1 2
0 3
Domestic Hot Water
Control Button
Central Heating
Control Button
Summer/Winter
Mode Button
o
C
Reset

2.0 Operating the Boiler

2.1 Introduction
1. Your Baxi Combi 130 HE is a gas fired, room
sealed, powered flue condensing combination
boiler, providing central heating for your home and
mains fed domestic hot water. It is fully automatic
and does not have a pilot light. Frost and pump
protection are an integral part of the appliance.
2. Priority is given to the hot water mode - when a
hot water tap is turned on the supply of heat to the
central heating circuit is interrupted.
3. Intelligent Pre-Heat: The boiler incorporates an
intelligent pre-heat feature. This ensures that the
domestic hot water to the tap is pre-heated only
when the user required hot water the previous
week. The pre-heat switches the boiler on for
approximately 1 minute every 40 minutes when
required. This function can be switched off if not
required.
3. A shortened version of these operating
instructions appears on the reverse of the lower
door panel. A label gives details of the model,
serial number, G.C.N o and the manufacturer's
name and address.
2.2 Operating the Boiler
1. Ensure that the electricity and gas supplies are
turned on.
2. Hinge down the lower door panel (Fig. 1).
3. Press the Summer/Winter mode button (
(Fig. 2) until the required setting is shown on the
Control Panel
indicates the summer setting and only hot
water will be provided when a tap or shower is
turned on.
indicates the winter setting and the central
heating will operate on demand or the hot water
will be provided when a tap or shower is turned on.
4. Priority is given to domestic hot water. The boiler
control system has an automatic time delay built in
for central heating. It is normal that following a
shutdown by the boiler thermostat, timer or
roomstat, there is a delay of approximately 3
minutes, before relighting.
5. The boiler will light automatically on demand.
6. The orange indicator on the badge will light
when the boiler is operating and the main burner is
on (Fig. 2).
7. To turn off the boiler: Press the On/Off/Reset
button ( ) until 00 appears on the display
Reset
(Fig. 2a). NOTE: This will disable boiler & system
frost protection. Press again to turn back on.
)