This Appliance Must Be Earthed - Baxi Combi 130 HE User Operating Instructions Manual

STANDARD SCOPE
B.S. 6891 Gas Installation.
B.S. 5440: Pt 1 Flues.
B.S. 5440: Pt 2 Air Supply.
B.S. 5546
Installation of hot water supplies
for domestic purposes.
B.S. 7074 Expansion vessels and ancillary
equipment for sealed water systems.
B.S. 5449: Pt 1 Forced circulation hot water systems.
B.S. 6798 Installation of gas fired hot water
boilers.
Treatment of water in domestic hot
B.S. 5793
water central heating systems.
IN AN EMERGENCY
If a water or gas leak occurs or is suspected, the boiler can be
isolated at the inlet valves as follows;
1. Turn off the electrical supply.
2. The isolating valves are positioned under the boiler and can be
closed using either a flat headed screwdriver or a 7mm open
ended spanner across the flats.
3. Turn the gas tap clockwise to the stop position to isolate the
gas supply at the boiler.
4. To isolate the water system, close the four valves fully by
turning clockwise.
5. Call your Service Engineer as soon as possible.
"Benchmark" Installation, Commissioning and Service
Record Log Book
Please ensure that your installer has completed the Installation
and Commissioning sections of the Log Book and hands the Log
Book over. The details of the Log Book will be required in the event
of any warranty work. Keep the Log Book in a safe place and
ensure that the relevant sections are completed at each
subsequent regular service visit.
All CORGI registered installers carry a CORGI identification card
and have a registration number. Both should be recorded in your
boiler Log Book. You can check your installer is registered by
telephoning 01256 372300 or writing to:-
1 Elmwood,
Chineham Business Park,
Crockford Lane,
Basingstoke.
RG24 8WG.
1.0 Warnings
1.1 Safe Installation
1. The installation must be carried out by a CORGI
Registered Installer or other registered competent
person and be in accordance with the relevant
requirements of the current G
(Installation and Use) R
EGULATIONS
R (Scotland)(Consolidation) the L
EGULATIONS
B R , the current I.E.E. W
UILDING EGULATIONS
R and the bye laws of the L
EGULATIONS
U . Where no specific instructions are
NDERTAKING
given, reference should be made to the relevant
BRITISH STANDARD CODES OF PRACTICE.
For Ireland install in accordance with I.S.813
"I G A
NSTALLATION OF AS PPLIANCES
should also be made to B
RITISH
N F T I
OTES OR HE NSTALLATION
C B .
ONDENSING OILERS
2. This appliance must be installed in accordance
with the manufacturer's instructions and the rules
in force, and only used in a suitably ventilated
location.
3. Read the instructions before installing or using
this appliance.
4. Any purpose provided ventilation should be
checked periodically to ensure that it is free from
obstruction.
IMPORTANT - The addition of anything that
may interfere with the normal operation of the
appliance without the express written
permission of Baxi UK Limited could invalidate
the appliance warranty and infringe the G
S (Installation and Use) R
AFETY
1.2 In case of gas leaks
1. If a gas leak is found or suspected, turn off the
gas supply at the meter immediately and at the
isolating valve on the boiler if possible. Contact your
Installer or Transco (under 'Gas' in the phone
directory). Do not operate any electrical equipment
or light switches.
1.3 Servicing your Appliance
For reasons of safety and economy your appliance
should be serviced annually. Your Installer or
British Gas Service will be able to advise you.
Important: To comply with the Gas Installation
and Servicing Regulations it is essential that
only a CORGI Registered Fitter services or
repairs this appliance.
WARNING: The condensate outlet must not be
blocked or modified.
1.4 Electricity Supply

1. THIS APPLIANCE MUST BE EARTHED.

2. A standard 230V ~ 50H z supply is required. The
appliance must be protected by a 3 amp fuse.
Never Hang Any Items Over The Appliance
S
AS AFETY
, the B
UILDING
OCAL
IRING
W
OCAL ATER
". Reference
G G
AS UIDANCE
O D G
F OMESTIC AS
AS
.
EGULATIONS
3