Table of Contents
Advertisement
turninG the appliance on
Please note!
Before turning the appliance on, make sure the main switch on
the back of the appliance is pressed (fig. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
•
To turn the appliance on, press the
The message "Heating up Please wait" is displayed.
After heating, the message "Rinsing" is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance has reached the required temperature when a
message is displayed indicating the coffee taste and quantity.
turninG the appliance off
Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the
The appliance performs a rinse cycle, then the message
"Turning off underway Please wait" is displayed and the
appliance goes off.
Please note!
If the appliance is not used for an extended period, switch off
the machine at the main switch (fig. 2).
Important!
To avoid damaging the appliance, never switch the appliance
off at the main switch before it has been turned off using the
button.
menu settinGs
When you access the programming menu by pressing the menu/esc
button, the following menu items are available:
rinsing
Use this function to deliver hot water from the spout to heat the internal
circuit and make the coffee delivered hotter.
button (fig. 7).
button (fig. 7).
10
To enable the function, proceed as follows:
1. Press the menu/esc button to enter the menu;
2. Press the milK or cappuccino button (fig. 8) until
"Rinsing" is displayed;
3. Press the
button. The message "Confirm?" is
displayed;
3. Press the
button (fig. 3). Hot water flows out of
the spout, heating the internal circuit and making the
coffee delivered hotter.
Descale
For instructions on descaling, see page 17.
adjust time
To adjust the time on the display, proceed as follows:
1. Press the menu/esc button to enter the menu;
2. Press the milK or cappuccino button (fig. 8) until
"Adjust time" is displayed;
3. Press the
button (fig. 3);
4. Press the milK or cappuccino button (fig. 8) to change
the hours;
5. Press the
button to confirm;
6. Press the milK or cappuccino button (fig. 8) to change
the minutes;
7. Press the
button to confirm.
This sets the time. Press the menu/esc button to exit the
menu.
auto-off
The auto-off time can be changed so that the appliance
switches off after 15 or 30 minutes, or after 1, 2 or 3 hours.
To re-programme Auto-off, proceed as follows:
1. Press the menu/esc button to enter the menu;
2. Press the milK or cappuccino button (fig. 8) until
"Auto-off" is displayed;
3. Press the
button;
4. Press the milK or cappuccino button (fig. 8) until the
desired operation time is displayed (15 or 30 minutes, or
1, 2 or 3 hours);
5. Press the
button to confirm;
6. Press the menu/esc button to exit the menu.
Auto-off is programmed.
auto-start
You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coffee immediately.
Please note!
To enable this function, the time must already have been set
correctly.
Advertisement
Table of Contents
Troubleshooting
