Displayed Messages - DeLonghi ECAM26455M Instructions For Use Manual

DisplayeD messaGes

DisplayeD messaGe
FILL TANK
EMPTY GROUNDS CONTAINER
GROUND TOO FINE ADJUST
MILL
alternating with
Insert water spout and press
OK
INSERT GROUNDS CONTAINER
ADD PRE-GROUNDCOFFEE
DESCALE!
LESS COFFEE
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
INSERT TANK
GENERAL ALARM
EMPTY CIRCUIT FILL CIRCUIT
alternating with
Hot water press OK
REPLACE FILTER
Press CLEAN
INSERT WATER SPOUT
INSERT MILK CONTAINER
possiBle cause
Insufficient water in the tank.
The grounds container (A22) is full.
The grinding is too fine and the coffee is delivered too slowly
or not at all.
After cleaning, the grounds container has not been repla-
ced
The "pre-ground coffee" function has been selected without
placing any pre-ground coffee in the funnel.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel is clogged.
The infuser has not been replaced after cleaning.
The tank is not correctly in place.
The inside of the appliance is very dirty.
The water circuit is empty
The water filter is exhausted.
Milk has been delivered recently and the tubes inside the
milk container must be cleaned.
The hot water spout is not inserted or is inserted incorrect-
ly.
The milk container is not inserted correctly.
remeDy
Fill the tank with water and/or insert it correctly, pushing it
as far as it will go until it clicks into place.
Empty the grounds container and drip tray, clean and replace
(fig. 26).
Important: when removing the drip tray, the grounds contai-
ner must be emptied, even if it is not completely full.
If this is not done, when you make the next coffees, the
grounds container may fill up more than expected and clog
the machine.
Repeat coffee delivery and turn the grinding adjustment
dial (fig. 12) one click clockwise towards "7" while the coffee
mill is in operation.
If after making at least 2 coffees delivery is still too slow,
repeat the correction procedure, turning the grinding
adjustment dial another click (see the section "adjusting the
coffee mill" on page 12).
Remove the drip tray and insert the grounds container.
Place pre-ground coffee in the funnel (fig. 17) or deselect
the "pre-ground" function.
The descaling procedure described in the "descaling" section
(page 17) needs to be performed as soon as possible.
Select a milder taste by pressing the
9) or reduce the quantity of pre-ground coffee, if using the
pre-ground function.
Fll the beans container (fig. 13).
Clear the funnel with the help of a brush as described in the
section "Cleaning the pre-ground coffee funnel".
Insert the infuser as described in the section "cleaning the
infuser".
Insert the tank correctly and press as far as it will go.
Clean the inside of the appliance thoroughly, as described in
the section "cleaning and maintenance".
If the message is still displayed after cleaning, contact
De'Longhi Customer Experience.
Connect the water spout (D3) (fig.6), fill the water tank and
press OK to deliver water from it, until it flows out normally.
Replace the filter or remove it as described in the section
"Water filter".
Press the CLEAN button (fig. 23) and keep it pressed until the
progress bar which appears on the display together with the
message "Cleaning underway " is complete.
Insert water spout (D3) as far as it will go.
Insert the milk container as far as it will go (fig. 21).
20
button (fig.