Olivetti d-Color MF 552 plus Installation Manual page 26

XXXIII. Adjusting registration of paper
source options
Note:
Performing this procedure is necessary only when
the paper feed cabinet PC-110/PC-210/PC-410 is
installed.
1. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
2. Select the function to be used as follows:
Machine → Printer Area → Printer Image Center-
ing Side 1 → 3rd.
3. Press the start key.
A test print will be produced.
4. Measure width A of the test pattern on the back-
side of the test print produced and check that it
falls within the specified range.
Specifications: 3.0 mm ± 1.0 mm
Paper exit
direction
5. If the measured width A falls outside the specified
range, see the installation manual of each paper
feed cabinet and make adjustments.
6. Produce another test print and check to see if
width A falls within the specified range.
7. Select the function to be used as follows:
Prt. Image Center. Side 2 (Dup) → 3rd.
8. Press the start key.
A test print will be produced.
9. Measure width A of the test pattern on the back-
side of the test print produced and check that it
falls within the specified range.
Specifications: 3.0 mm ± 2.0 mm
Paper exit
direction
Installation Manual
A
4061IXC152DA
A
4061IXC152DA
E-26
10. If the measured width A falls outside the speci-
fied range, enter the correction value using the
or key.
* When the tray 4 is available with the optional
paper feed cabinet, check the tray and make
adjustments in the same way.
11. Produce another test print and check to see if
width A falls within the specified range.
12. Touch "END."
13. Touch "Exit" on the Service Mode screen.
14. Turn OFF and ON the Main Power Switch.
Note:
When displayed the Service Mode screen, be sure
to turn off the main power after exiting the Service
Mode screen and wait for 10 seconds or more
before turning on.
XXXIV. Installing the user's guide holder/
spacer
Install the user's guide holder and the spacer.
A2XKIXC020DA
Y115290-3