Solid State Digital Control - Blodgett Mark V Installation Operation & Maintenance

Mark V
Solid State
1
2
LOW FAN
3
8
7
10
WARNING
10 AF
REPLACE WITH 10 AMP
TIME DELAY FUSES
DISCONNECT FROM THE SOURCE OF
SUPPLY BEFORE SERVICING
www.blodgett.com
Figure 11
HIGH
FAN
4
5
6
9
11
10 AF

Solid State Digital control

controL DeScriPtion
1. SELECTOR SWITCH - turns power to the oven on or off.
Allows selection of Cook or Cool Down Modes and fan
speed (if applicable).
2. DISPLAY - displays time or temperature and other infor-
mation related to oven function.
3. HEAT LAMP - lights when heater is on.
4. PULSE LAMP - lights when Pulsed Fan Mode is turned
on.
5. HOLD LAMP - lights when Hold Mode is turned on.
6. DIAL - used to enter set points in display
7. START/STOP KEY - starts or stops the timer.
8. TIME KEY - used to show time in the display.
9. TEMP KEY - used to show set temperature in the display.
NOTE: Actual temperature is shown while the TEMP
key is held down.
10. HOLD KEY - turns Hold Mode on or off.
11. PULSE KEY - turns Pulse Mode on or off.
ProGraMMinG
to set the cook temperature:
1. Press TEMP (9) key.
2. Rotate dial (6) to enter temperature.
to set the cook time:
1. Press TIME (8) key.
2. Rotate the dial (6) to enter time.
NOTE: Time is entered in hours : minutes or minutes :
seconds.
to set the hold time:
1. Press HOLD key (10) to turn hold mode on.
NOTE: HOLD light is on.
2. Rotate dial (6) to enter the hold temperature.
3. Press START/STOP key (7)
to set the pulse time:
1. Press PULSE KEY (11) to turn pulse mode on.
NOTE: Pulse light is on.
2. Rotate DIAL (6) to enter the pulse time. Pulse time is a
portion of the pre-set cook time.
13
Operation