Solid State Digital Control - Blodgett MARK V-100 XCEL Installation Operation & Maintenance

Operation

Solid State Digital control

1
2
3
8
7
10
12
Figure 10
control DeScriPtion
1. SELECTOR SWITCH - turns power to the oven on
or off. Allows selection of Cook or Cool Down Modes
and fan speed (if applicable).
2. DISPLAY - displays time or temperature and other in-
formation related to oven function.
3. HEAT LAMP - lights when heater is on.
4. PULSE LAMP - lights when Pulsed Fan Mode is
turned on.
5. HOLD LAMP - lights when Hold Mode is turned on.
6. DIAL - used to enter set points in display
4
7. START/STOP KEY - starts or stops the timer.
8. TIME KEY - used to show time in the display.
5
9. TEMP KEY - used to show set temperature in the dis-
play.
NOTE: Actual temperature is shown while the
6
10. HOLD KEY - turns Hold Mode on or off.
9
11. PULSE KEY - turns Pulse Mode on or off.
12. LIGHTS SWITCH - controls interior lights.
11
13. CIRCUIT BREAKER SWITCH - controls power to the
oven.
ProGramminG
to set the cook temperature:
1. Press TEMP (9) key.
2. Rotate dial (6) to enter temperature.
to set the cook time:
1. Press TIME (8) key.
2. Rotate the dial (6) to enter time.
NOTE: Time is entered in hours:minutes (0:00) or
13
to set the hold time:
1. Press HOLD key (10) to turn hold mode on.
NOTE: HOLD light is on.
2. Rotate dial (6) to enter the hold temperature.
3. Press START/STOP key (7)
12
TEMP key is held down.
minutes:seconds (00:00).