Table of Contents
Advertisement
CAM ID
BAUD RATE
PROTOCOL
DISP MODE
DISP ITEM
1
2
TITLE
ALARM TEXT
SAVE
NOTE 1 : You can choose BPS menu appropriate for keyboard protocol.
NOTE 2 : Although you change BAUD RATE or PROTOCOL menu,
the terms of change is not applied unless you select SAVE menu.
NOTE 3 : Does not do power source down while saving
6
Troubleshooting and Maintenance
6.1 TROUBLESHOOTING
If problems occur, verify the installation of the camera with the instruction in this
manual and with other operating equipment.
Isolate the problem to the specific piece of equipment in the system and refer to
the equipment manual for further information.
PROBLEM
Nothing appears on the screen
The image on the screen is dim.
PROBLEM
The camera is not working
properly and the surface of the
camera case is hot.
The contrast on the screen is
too weak.
Select the camera ID.(1~255)
Select serial communication speed. (2400/4800/9600/19200bps)
Select operating protocol.
(FASTRAX/PELCO-P/PELCO-D/COMMAND)
Select display mode.(ON/OFF/PUSH ON)
Select display item.(1~2)
Camera Title and ID display.
Camera Title and ID, Zoom lens position display.
Select camera title menu.(A~Z, 0~9)
ABCDEFGHIJ
KLMNOPQRST
UVWXYA 0123
456789
( ) :
; . - ¡æ¡ç ! < > , '
¡ç¡æ < > S E
If the alarm is occurred, the ALARM TEXT established at this menu
will be displayed.
Save preset parameters of CAM SET MENU.
Are the power cord and line connection between the
camera and monitor made properly?
Is the lens dirty?
If so, clean the lens with a soft, clean cloth.
Is the camera connected to the proper power?
Adjust the contrast feature of the monitor.
Is the camera exposed to strong light?
If so, change the camera position.
POSSIBLE SOLUTION
POSSIBLE SOLUTION
14
Advertisement
Table of Contents
