Hitron 50201270 Instruction Manual page 12

3.2.2 INSTALLATION 2
A. Drill the mounting location, using the bottom of the mount base as a template.
B. Insert the plastic anchors into the hole which has just drilled.
C. Connect BNC cable and communication lines.
D. Fit the screw holes of the mount base into the plastic anchors.
E. Remove the conduit knockout punched for the cable entry.
F. Screw up the M6 torx screws(T-20).
G. Adjust the camera suitably using the pan & tilt function, and fix the camera
using the socket set screw, hexagon wrench.
(Using the conduit knockout punched with Mount Base)
Mount Base
Socket Set Screw
M5.0, L=5.0mm
Torx Screws (T-20)
M6.0 x 35.0 (4x)
Wall
Plastic
Anchors (4x)
Hexagon Wrench
5
A conduit knockout punched
for the cable entry
Cable