Hitron 50201270 Instruction Manual page 11

3.2.1 INSTALLATION 1
A. Drill the mounting location, using the bottom of the mount base as a template.
B. Insert the plastic anchors into the hole which has just drilled.
C. Connect BNC cable and communication lines.
D. Fit the screw holes of the mount base into the plastic anchors.
E. Screw up the M6 torx screws(T-20).
F. Adjust the camera suitably using the pan & tilt function, and fix the camera
using the socket set screw, hexagon wrench.
* Seal around the stand base tightly using the silicon rubber.
(Cable through the wall with the mount base)
Mount Base
Set Screw
M5.0, L=5.0mm
Torx Screws (T-20)
M6.0 x 35.0 (4x)
4
Wall
Plastic Anchors (4x)
Socket Set Screw
M5.0, L=5.0mm
Hexagon Wrench