Table of Contents
Advertisement
28. Put a lockwasher
and hex nut on the bolt
and tighten using a 7/16 inch wrench
or sock-
et.
29. Repeat
steps 27-28 with the left spacer.
30. Move the cabinet
to the location
where
you will use your saw.
31. Put a hex nut on each of the leveling feet.
(Figure
56)
Fig. 56 - Hex Nut for Leveling Foot
32. Put the leveling feet through
the holes in
the bottom
of the side panels,
at the four
corners
of the shelf.
33. Put another hex nut on each of the level
ingfeet and hand-tighten
until they are
agairkst the side panels.
a'k
WARNING:
Saw blade
can roll for-
ward toward
you if the leveling
feet are
not correctly
adjusted.
Workpiece
or
saw can move
unexpectedly
if cabinet
rocks.
Fingers,
hand, or arm can be cut
off from
blade
contact.
Adjust
leveling
feet before
using
your saw.
34. If the leveling feet raise the front of the
saw slightly higher
than the rear, and if the
cabinet
does not rock, go to step 40, or
If the leveling feet do not raise the front of
the saw slightly higher than the rear, go to
step 35, or
If the cabinet
rocks, go to step 35.
35. Loosen
the bottom
hex nut on the desired
leveling foot using a 9/16 inch wrench.
36. Loosen
the top nut by hand.
37. Adjust the lower nut with the 9/16 inch
wrench
until the leveling foot is at the desired
height.
38. Tighten
the top nut by hand.
39. Repeat
steps 35-38 for the other three
leveling feet if necessary.
40. Tighten
all four bottom
nuts using a 9/16
inch wrench.
41. Slide the upper support into the front sup-
port to form an inverted L-shaped unit. Four
holes in each part should line up: two holes
at the top of the "L", and one hole on each
side. (Figure 57)
o-.
,
Upper Support
nt Support
- Solid Surface
Fig. 57
42. Put two truss head bolts through
the holes
on the sides of the "L". Put a lockwasher
and
hex nut on each bolt and hand-tighten.
43. Put the L-shaped
assembly
into place in
the cabinet.
The upper support
should
extend
between
the front and rear skirts, and the
front support
should extend between
the front
skirt and the angled
end of the lower support.
(Figure
58)
23
Advertisement
Table of Contents
