Craftsman 113.198411 Operator's Manual page 10

The following loose parts are included with
both models:
A.
B.
Handwheel ....................... 1
Arbor Wrenches .................. 2
Ci
D.
E.
G°
H.
Jo
K.
L.
M.
N.
Yoke Plug ....................... 1
Yellow On/Off Key ............... !
Battery 6V, alkaline, size J ......... 1
Motor Support Cap ............... !
Pan Head Screw 10-32xl/2 ......... 1
Lockwasher 10 .................... 1
Battery Cover .................... 1
Locknuts 1/4-20 ................... 2
Washers 17/64x5/8x1/32 ............ 4
Hex Head Bolts 1/4-20x5/8 ......... 4
Lockwashers 1/4 .................. 4
Hex Nuts 1/4-20 .................. 2
O,
P.
O.
R.
S.
T.
U.
V.
W.
Mounting Screws 1/4-20xl-3/4 ...... 5
Washers 17/64x5/8x1/32 ............ 5
Rubber Grommets ................ 5
U-Clips 1/4-20 .................... 5
Tee Nuts ......................... 3
Leveling Screws 1/4-20x7/8 ......... 3
Pan Head Screws 1/4 x 1-1/4 ........ 4
Washers 17/64x3/4xl!16 ............ 4
White Buttons .................... 2
X.
Y.
Z.
Right Table Rail .................. 1
Left Table Rail ................... 1
Lock Handles with Rods .......... 2
II, o=
©°
I}i; R
©v
._ z %
Fig. 15 - Loose Parts, Both Models
Information
Both Models
1. If you are missing any part while putting
your saw together, do not continue assembly.
Contact your Sears Service Center or Retail
Store and get the missing part before continu-
ing assembly or trying to use the saw.
Complete parts lists are located at the end of
this manual. Use these lists to identify the
number of any missing part.
2. Sometimes small parts get lost in packag-
ing materials. Do not throw away any packag-
ing until your saw is put together. If you are
missing a part, check the packaging before
contacting Sears.
3. Most parts of your radial arm saw will be
fastened together using truss head bolts, lock-
washers, and hex nuts of the sizes shown.
(Figure 16) When different sizes are needed,
the instructions will include a sketch to help
you locate the correct size.
10