Craftsman 113.198411 Operator's Manual page 16

Rear
Short
Long Tabs
Right Side Panel
Inside Edge Of Side Panel
Front
Fig. 35
7. Repeat steps 4 - 6 with another rear sup-
port and the left side panel. Attach the slide
brackets to the right side of this rear support
8. Attach the front end of each slide bracket
to a hole on the inside edge of the sidepanels
with six truss head bolts. Put a lockwasher
and hex nut on each bolt and tighten with a
7/16 inch wrench or socket. (Figure 35)
9. Lay the shelf on the rear edge with the bot-
tom side toward you. The angled end of the
lower support should point up.
10. Place the fight sidepanel on the right side
of the shelf. The slide brackets should be on
the inside of the cabinet. (Figure 36)
Angled End Of
Support
Bottom Side Of Shelf
Right Side Panel
11. Put bolts through the four holes along the
bottom edge of the Hght side panel. Put a
lockwasher and hex nut on each bolt and
tighten using a 7/16 inch wrench or socket.
(Figure 36)
Note: It is sometimes difficult to get bolts
through these four holes. You may need to
use a Phillips screwdriver to help shift the
parts into place.
12. Repeat steps 10 - 11 with the left side
panel and the left side of the shelf.
13. Turn the cabinet so that it is on the
wheels. Attach the skirts to the top of the side
panels, with one on the front of the cabinet
and the other on the back. (Figure 37)
Rear
Side Panel
Shelf
Left Side Panel Front
Skirt
Fig. 37
14. Use eight truss head bolts to hold the
skirts in place. Put a lockwasher and hex nut
on each bolt and hand-tighten. (Figure 37)
15. Put a truss head bolt through the hole at
the back, right corner of the shelf. This hole
goes through the shelf and right side panel.
(Figure 38)
Fig. 36
16