Dell Networking N4000 Series Configuration Manual page 297

Figure 12-13. Add SNTP Server
3 In the SNTP Server field, enter the IP address or host name for the new
SNTP server.
4 Specify whether the information entered in the SNTP Server field is an
IPv4 address, IPv6 address, or a hostname (DNS).
5 If you require authentication between the SNTP client on the switch and
the SNTP server, select the Encryption Key ID check box, and then select
the key ID to use.
To define a new encryption key, see "Adding an SNTP Authentication Key"
on page 294.
NOTE:
information to allow time synchronization to take place between the two
devices.
The SNTP server must be configured with the same authentication
Managing General System Settings
297