Managing The Stack (Cli); Configuring Stack Member, Stack Port, And Nsf Settings - Dell Networking N4000 Series Configuration Manual

Managing the Stack (CLI)

This section provides information about the commands you use to manage
the stack and view information about the switch stack. For more information
about these commands, see the
Series Switches CLI Reference Guide at support.dell.com/manuals.

Configuring Stack Member, Stack Port, and NSF Settings

Beginning in Privileged EXEC mode, use the following commands to
configure stacking and NSF settings.
Command
configure
current_ID
switch
new_ID
renumber
stack
initiate failover
unit
standby
set description
192
Managing a Switch Stack
Purpose
Enter Global Configuration mode.
Change the switch ID number. The valid range is 1-10.
NOTE:
Changing the ID number causes all switches in the
stack to be reset to perform stack master renumbering. The
running configuration is cleared when the units reset.
Enter Global Stack Configuration mode.
Move the management switch functionality from the
master switch to the standby switch.
Specify the stack member that will come up as the master
if a stack failover occurs.
unit
Configure a description for the specified stack member.
Dell Networking N2000, N3000, and N4000