Troubleshooting - Clarke Vantage 17 E Instructions For Use Manual

TROUBLESHOOTING

Trouble
The motors do not turn on.
The brush motor does not run.
The vacuum system motor does not
turn on.
The dirty water vacuuming is
insufficient.
The solution flow is insufficient.
The squeegee leaves marks on the
floor.
(*) This maintenance procedure must be performed by an authorised Clarke Service Center.
For further information, refer to the Service Manual, available at any Clarke Service Center.
Possible Cause
The power supply cable is faulty or disconnected from
the electrical mains.
The switch (26) is broken.
The push-buttons (51) are broken.
The switch (52) is broken.
The switch (53) is broken.
The recovery tank is full.
The vacuum grid is clogged or the float is closing.
The vacuum hose is disconnected from the squeegee
or faulty.
The squeegee is dirty, or the squeegee blades are
worn or damaged.
The recovery tank cover is not properly closed, or the
gasket is damaged.
The vacuum system motor filter is dirty.
The solution filter is dirty.
The solution solenoid valve is faulty.
There is debris under the squeegee blades.
The squeegee blades are worn, chipped or torn.
INSTRUCTIONS FOR USE
Remedy
Replace (*) or connect the cable.
Replace. (*)
Replace. (*)
Replace. (*)
Replace. (*)
Empty.
Clean the grid and check the float.
Connect.
Clean the squeegee or replace the blades.
Check and/or clean the seating surface or replace
the gasket.
Clean.
Clean.
Replace. (*)
Remove the debris.
Replace the blades.
9099653000 - VANTAGE 17 E
ENGLISH
21