After Using The Machine; Recovery Tank Removal; Machine Long Inactivity; First Period Of Use - Clarke Vantage 17 E Instructions For Use Manual

ENGLISH
Recovery tank emptying
1. To turn off the machine, turn the main switch (26) to "0".
2. Disconnect the power supply cable plug (21) from the electrical mains and place it on the holder.
3. Lift the squeegee (46).
4. Drive the machine to the appointed disposal area.
5. Insert the positioning pin (24) and lift the brush/pad-holder by engaging the transport/parking device (23a).
6. Empty the recovery tank (27) with the drain hose (16). Then, rinse the tank with clean water.
Solution tank emptying
Perform steps 1 to 4.
7. Empty the solution tank (28) with the hose (18).
8. Then, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brush/pad-holder as shown in the Machine
Transport/Parking paragraph.
2. Disconnect the power supply cable plug (21) from the
electrical mains and place it on the holder.
3. Empty the tanks (27 and 28) as shown in the previous
paragraph.
4. Perform the daily maintenance procedures (see the
Maintenance chapter).
5. Store the machine in a clean and dry place, with the brush/
pad-holder and the squeegee lifted or removed.

RECOVERY TANK REMOVAL

To perform check and maintenance procedures, it may be
necessary to remove the recovery tank (27) as shown below.
1. Empty the recovery tank (27) as shown in the relevant
paragraph.
2. Drive the machine on a level floor.
3. Make sure that the power supply cable plug (21) is
disconnected from the electrical mains.
4. Disconnect the vacuum hose (22) from the squeegee (11).
5. Disconnect the recovery water drain hose (16) from the
bracket (17).
6. Open the cover (6).
7. Grasp the recovery tank (A, Fig. 6) in the area (B) and
slightly raise it.
8. Disconnect the vacuum hose (C) from the tank, then
remove the tank (A) with the hoses (D) and (E).

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine paragraph.
2. Store the machine in a clean and dry place.

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
16
INSTRUCTIONS FOR USE
VANTAGE 17 E - 9099653000
A B
C
D
Figure 6
E
P100641