Machine Operation (Scrubbing/Drying) - Clarke Vantage 17 E Instructions For Use Manual

ENGLISH
Squeegee lifting
Lift the squeegee as indicated below:
1. Grasp the handlebar (2), lower it until the rear wheel (7)
touches the floor (A, Fig. 3) then engage the squeegee in
lifted position (B).

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor.
3. If necessary, adjust the solution quantity by using the push-button (54).
CAUTION!
To avoid damaging the floor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the push-buttons (51).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the push-buttons (51).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Clarke suggests to go near the walls with the right side of
the machine as shown in figure 4.
Machine speed adjustment
4. The machine speed varies according to the type of floor to be cleaned and the choice of using the brush or the pad. If
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
14
INSTRUCTIONS FOR USE
A A
VANTAGE 17 E - 9099653000
Figure 4
clik
A
B
Figure 3
B
P100642
P100643