Kyocera Mita mita KM-P4850w Operation Manual page 59

TROUBLE
Film is sticky with ink after
printing.
Film curls after printing.
The print data and the printed
image differ in size.
The printed image is light.
Text is not being printed
correctly.
Print out is not correct.
CHECK POINT
Is film selected as the media type?
Is film selected as the media type?
Is the fixing temperature proper?
Is the media type setting correct?
Is the message indicating toner
replenishment displayed?
Is the paper wet?
Is the network cable appropriate and
is it connected properly?
Is your computer configured
correctly?
CHAPTER 6 TROUBLESHOOTING
PROCEDURE
Select film for the media type setting.
Select film for the media type setting.
Adjust the fixing temperature to a lower temperature.
Select the appropriate media type for the media type
setting.
Replenish toner.
Replace the paper roll with a new one. Depending
on the operating environment, turn the dew
prevention heater switch on.
Make sure that an appropriate network cable is
being used and make sure that it is connected
properly.
Make sure that the settings in the software
application being used are correct.
PAGE
5-6
5-6
5-9
5-6
6-3
3-7
3-9
—
—
6-13