Kyocera Mita mita KM-P4850w Operation Manual page 58

CHAPTER 6 TROUBLESHOOTING
TROUBLE
Paper jams often.
The printed image is shifted to
either side (widthwise).
Paper is wrinkled or curled.
Toner does not adhere well to
the paper.
6-12
CHECK POINT
Are there wrinkles or folds in the
paper?
Is there any jammed paper or are
there other pieces of paper
remaining inside the machine?
Is the paper setting method proper?
Is vellum being used?
Is the paper roll properly installed
into the roll unit?
Was the paper fed properly in
bypass mode?
Is the media type setting correct?
Is the paper wet?
Is the roll unit flange set properly?
Is the fixing temperature proper?
Is the media type setting correct?
Was thick paper used?
PROCEDURE
Remove the portion of the paper roll that contains
the wrinkles or folds.
Remove them by following the appropriate
procedure.
Check the paper setting method.
The leading edge may have been damaged.
Pull out the paper roll until the damaged portion
comes out and then cut it before use.
Align the flange guide positions with the appropriate
size labels.
Adjust the bypass guides to the paper size and then
insert the paper.
Select the appropriate media type for the media type
setting.
Replace the paper roll with a new one. Depending
on the operating environment, turn the dew
prevention heater switch on.
Set the roll unit flange properly.
Adjust the fixing temperature to a lower temperature.
Select the appropriate media type for the media type
setting.
Adjust the fixing temperature to a higher
temperature.
PAGE
—
6-7
3-7
—
3-7
4-2
5-6
3-7
3-9
3-7
5-9
5-6
5-9