Kyocera Mita mita KM-P4850w Operation Manual page 54

CHAPTER 6 TROUBLESHOOTING
2 Grasp the printer body release lever and pull it toward you.
The printer body will be opened.
WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is
a danger of electrical shock.
CAUTION
The printer's fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.
3 If the jammed paper is present, pull it out.
* If it is difficult to pull it out, do not pull too hard but simply
proceed to the next step.
4 Turn the transport knob counterclockwise to feed the jammed
paper.
6-8
5 If the paper is present, remove it from inside the printer.
6 Push the ejection release lever toward you. The ejection
cover will be opened.
CAUTION
The printer's fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.
7 Remove the jammed paper.
IMPORTANT
When opening the ejection cover, be sure to pull out the original table
in advance.