Kyocera Mita mita KM-P4850w Operation Manual page 56

CHAPTER 6 TROUBLESHOOTING
Grasp the handles A of the roll unit to unlock the unit and
2
pull out the roll unit until it stops.
A
3 Grasp the flange and rewind the paper roll.
4 If there is any wrinkled or folded area, remove it with a
cutting knife or scissors.
Grasp both of the paper roll insertion latches 3 and open
5
the paper roll insertion cover 4.
3
6-10
A
4
3
6 Insert the leading edge of the paper under the paper roll
insertion guide and advance the edge past the guide
approximately 1/2" [10 mm] as shown in the illustration.
7 Grasp both of the paper roll insertion latches and close the
paper roll insertion cover.
IMPORTANT
If the paper roll that has been loaded has slackened, grasp the flange
and wind the paper roll to remove the slack. If not, the paper may be
fed obliquely.
8 Push the roll unit securely back into the machine.
9 Close the front cover.
10 If the leading edge of the paper is not cut straight, press the
Roll Cut key.
The leading edge of the paper will be cut.