Ip Routing Mode - Cisco Small Business Pro SA 520W Administration Manual

Networking
Configuring IPv6 Addressing
STEP 1
STEP 2
STEP 3
STEP 4
NOTE
Cisco SA 500 Series Security Appliances Administration Guide

IP Routing Mode

To get started with the IPv6 configuration, first enable IPv4/IPv6 mode. IPv4 and
IPv6 addressing are supported.
Click Networking on the menu bar, and then click IPv6 > Routing Mode in the
navigation tree.
The Routing Mode page appears.
Click IPv4/IPv6 mode to enable IPv6 addressing, or click IPv4 only mode to
enable only IPv4 addressing.
Click Apply to save your settings, or click Reset to revert to the saved settings.
When the warning appears, click OK to continue. If you do not want to change the
IP mode, click Cancel.
Next steps:
• To configure the WAN connection, click IPv6 > IPv6 WAN Config. For more
information, see
• To configure the LAN, click IPv6 > IPv6 LAN Config. For more information,
see Configuring the IPv6 LAN, page
Configuring the IPv6 WAN Connection, page
93.
3
92.
91