Profile Advanced Configuration - Cisco Small Business Pro SA 520W Administration Manual

Wireless Configuration for the SA 520W
Configuring an Access Point
STEP 5
STEP 6
NOTE
STEP 1
STEP 2
Cisco SA 500 Series Security Appliances Administration Guide
• WEP Key Index: Based on which WEP key box is used, WEP key index is
derived. Different clients can have different numbering scheme for index. For
clients which have indexing starting with 0, WEP Key 1 to WEP Key 4
corresponds to index 0 to 3. Clients which have indexing starting with 1, WEP
Key 1 to WEP Key 4 correspond to index 1 to 4.
Click Apply to save your settings, or click Reset to revert to the saved settings.
Repeat this procedure as needed to add more wireless profiles.
Next steps:
• Required for each access point: Configure and enable the access point.
See Step 2: Configuring the Access Points, page
• If you need to configure advanced settings, click the Advanced Config
button in the List of Profiles table. For more information, see
Advanced Configuration, page
• If you need to configure QoS settings, click the QoS Config button in the
List of Profiles table. For more information, see
Settings for a Wireless Profile, page
• If you want to configure MAC Filtering, click the MAC Filtering button in the
List of Available Access Points table. For more information, see
Wireless Access Based on MAC Addresses, page
• For RADIUS authentication, configure the RADIUS settings. See
Configuring RADIUS Server Records, page

Profile Advanced Configuration

Click Wireless on the menu bar, and then click Profiles in the navigation tree.
The Profiles page appears. The existing profiles appear in the List of Profiles table.
Find the profile that you want to edit, and click the button in the Adv Config
column.
113.
109.
Configuring the QoS
110.
111.
208.
4
Profile
Controlling
109