Creating The Ssl Vpn Policies - Cisco Small Business Pro SA 520W Administration Manual

Configuring VPN
Configuring SSL VPN for Browser-Based Remote Access
STEP 3
STEP 4
Cisco SA 500 Series Security Appliances Administration Guide
The User Configuration page appears.
Enter the following information:
• User Name: Enter a unique identifier for the user. It can include any
alphanumeric characters.
• First Name: Enter the user's first name.
• Last Name: Enter the user's last name.
• User Type: Choose SSL VPN User.
• Select Group: Choose SSLVPN.
• Password: Enter a password that contains alphanumeric, '—' or '_'
characters.
• Confirm Password: Enter the password again.
• Idle Timeout: Enter the time in minutes that the user can be inactive before
the session is disconnected. Enter any value from 0 to 999. The timeout value
for the individual user has precedence over the timeout for the group. If the
user's timeout value is set to 0, the group timeout setting applies.
Every user is added as a local user with password, and when the user
NOTE
is assigned to an external authentication mechanism based on the group,
certain attributes such as the local password are ignored.
Click Apply to save your settings, or click Reset to revert to the saved settings.

Creating the SSL VPN Policies

SSL VPN Policies give configured SSL users access to services and network
resources. A policy applies to a specific network resource, IP address, or IP
address range on the LAN, or to other SSL VPN services that are supported by the
security appliance.
By default, a global PERMIT policy (not displayed) is preconfigured over all
addresses and over all services and ports.
You can create user, group, and global policies. Policies are applied based on the
following levels of precedence:
• User-level policies take precedence over Group-level policies.
• Group-level policies take precedence over Global policies.
8
173