Homelink ® Wireless Control System - Volvo XC90 Owner's Manual

Introduction
1
The HomeLink Wireless Control System pro-
vides a convenient way to replace up to three
hand-held radio-frequency (RF) transmitters
used to activate devices such as gate opera-
tors, garage door openers, entry door locks,
security systems, even home lighting. Addi-
tional HomeLink information can be found on
the Internet at www.homelink.com or by
phoning the hotline at 1–800–355–3515.
HomeLink and the HomeLink house are registered trademarks of Johnson Controls, Inc.
1
WARNING
•
If you use HomeLink to open a garage
door or gate, be sure no one is near
the gate or door while it is in motion.
•
When programming a garage door
opener, it is advised to park outside of
the garage.
•
Do not use HomeLink with any garage
door opener that lacks safety stop and
reverse features as required by U.S.
federal safety standards (this includes
any garage door opener model manu-
factured before April 1, 1982). A
garage door that cannot detect an
object - signaling the door to stop and
reverse - does not meet current U.S.
federal safety standards. For more
information, contact HomeLink at:
www.homelink.com.
Retain the original transmitter of the RF
device you are programming for use in other
vehicles as well as for future HomeLink pro-
gramming. It is also suggested that upon the
sale of the vehicle, the programmed Home-
Link buttons be erased for security purposes.
Refer to "Resetting HomeLink Buttons" on
page 91.
02 Instruments and controls
HomeLink ® Wireless Control System*
Programming HomeLink
NOTE
Some vehicles may require the ignition to
be switched on or be in the "accessories"
position for programming and/or operation
of HomeLink. It is also recommended that
a new battery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink for quicker training
and accurate transmission of the radio-fre-
quency signal. The HomeLink buttons
must be reset first. When this has been
completed, Homelink is in learning mode
so that you can perform programming.
1. Position the end of your hand-held trans-
mitter 1–3 inches (5–14 cm) away from
the HomeLink button you wish to pro-
gram while keeping the indicator light in
view.
2. Simultaneously press and hold both the
chosen HomeLink and hand-held trans-
mitter buttons until the HomeLink indica-
tor light changes from a slow to a rapidly
blinking light. Now you may release both
the HomeLink and hand-held transmitter
buttons.
*
Option/accessory, for more information, see Introduction.
02
89