Power moonroof
To operate the moonroof, turn the ignition key
to position I or II, or start the engine. The
moonroof can be operated in two ways:
Tilt position
Sliding moonroof
A position where the moonroof is not quite fully open, which helps alleviate "rumbling" wind noise.
1
Tilt position
Open: With the moonroof closed, push up the
rear edge of the switch (position 5 in the illus-
tration in the center column).
Close: Pull down and hold the rear edge of
the switch (position 6 in the illustration in the
center column) until the moonroof has closed
completely.
Sliding moonroof
Manual open: Pull the switch rearward to
position 3 and hold it until the moonroof has
opened to the position of your choice.
02 Instruments and controls
Power moonroof
Auto open: Pull the switch as far back as
possible (position 4) and release it to auto-
matically slide open the moonroof to the
1
"comfort"
position. Pull the switch rearward
again to open the moonroof completely.
Manual close: Push the switch to position 2
and hold it until the moonroof has closed
completely or to the position of your choice.
Auto close: Push the switch forward as far as
possible (position 1) and release it to auto-
matically close the moonroof.
CAUTION
•
Remove ice and snow before opening
the moonroof.
•
Do not operate the moonroof if it is
frozen closed.
•
Never place heavy objects on the
moonroof.
02
87