Supplemental Restraint System - Volvo XC90 Owner's Manual

Supplemental Restraint System (SRS)
SRS warning light
As an enhancement to the three-point seat
belts, your Volvo is equipped with a Supple-
mental Restraint System (SRS). Volvo's SRS
consists of seat belt pretensioners, front air-
bags, side impact airbags, the occupant
weight sensor, and inflatable curtains. All of
these systems are monitored by the SRS
control module. An SRS warning light in the
instrument panel (see the illustration) illumi-
nates when the ignition key is turned to posi-
tion I, II, or III, and will normally go out after
approximately 7 seconds if no faults are
detected in the system.
Where applicable, a text message
will also be displayed when the
SRS warning light illuminates. If
this warning symbol is not func-
tioning properly, the general
warning symbol illuminates and a text mes-
sage will be displayed.
WARNING
•
If the SRS warning light stays on after
the engine has started or if it illumi-
nates while you are driving, have the
vehicle inspected by a trained and
qualified Volvo service technician as
soon as possible.
•
Never try to repair any component or
part of the SRS yourself. Any interfer-
ence in the system could cause mal-
function and serious injury. All work on
these systems should be performed by
an authorized Volvo service technician.
01 Safety

Supplemental Restraint System

WARNING
If your vehicle has been subjected to flood
conditions (e.g. soaked carpeting/standing
water on the floor of the vehicle) or if your
vehicle has become flood-damaged in any
way, do not attempt to start the vehicle or
put the key in the ignition before discon-
necting the battery (see below). This may
cause airbag deployment which could
result in personal injury. Have the vehicle
towed to a trained and qualified Volvo
service technician for repairs.
Automatic transmission:
Before attempting to tow the vehicle, use
the following procedure to override the
shiftlock system to move the gear selector
to the neutral position:
1. Switch off the ignition for at least
10 minutes and disconnect the bat-
tery.
2. Wait at least one minute.
3. Insert the key in the ignition and turn it
to position II
4. Press firmly on the brake pedal.
5. Move the gear selector from P (Park)
to the N (Neutral) position.
01
23