Volvo XC90 Owner's Manual page 109

3. With the MEM button depressed, press
button 1 briefly to store the seat's current
position.
To move the seat to the position that it was in
when button 1 was programmed:
Press and hold down button 1 until the seat
stops moving.
As a safety precaution, the seat will stop
automatically if the button is released before
the seat has reached the preset position.
Front seats*
Massage
Lumbar support
Massage
Massage control
Firm massage
Gentle massage
Each front seat has a massage function in its
backrest. The massage action is done with air
cushions, which can be adjusted to a firm or
gentle setting. When the setting has been
made, the massaging action is carried out in
cycles as follows: massage 6 minutes –
pause 4 minutes – massage 6 minutes, etc.
When the button is in the center position or if
the ignition is in position 0, the massage func-
tion is switched off.
Lumbar support
Lumbar support control
The lumbar support uses the same air cush-
ions as the massage function. The button can
be used to adjust the amount of support in
four directions, as shown in the illustration.
Lumbar support can be only be adjusted
when the massage function is switched off.
A memory function stores the lumbar support
setting and this support will resume after the
massage function has been switched off or
after the vehicle has been parked for an
extended period of time.
*
Option/accessory, for more information, see Introduction.
04 Interior
Front seats
04
107