Volvo XC90 Owner's Manual page 87

1. Switch the ignition to position II.
2. Press the button on the rear side of the
mirror with straightened paperclip or simi-
lar object for approximately 3 seconds
ZONE
until is displayed. The number of
the current magnetic zone will also be
displayed.
3. Press the button repeatedly until the
number for the desired zone (1 – 15) is
displayed.
Z
C
O
A
N
L
E
Calibrating the compass
After several seconds, the compass heading
will again be displayed, and the change of
magnetic zones is complete.
Calibrating the compass
1. Stop the car in a large, open area, away
from traffic.
2. Turn off as many electrical devices in the
car as possible to avoid interference with
the compass (e.g. audio system, etc).
3. Using a pen or similar object, hold the
button (on the rear side of the mirror)
depressed for at least 6 seconds. "
will be displayed.
4. Drive slowly in a circle at a maximum
speed of 5 m.p.h. (8 km/h) until
longer displayed.
NOTE
This step can also be done by driving nor-
mally until CAL is no longer displayed.
Calibration is complete.
02 Instruments and controls
Power door mirrors
CAL "
CAL
is no
The mirror control switches are located on
the driver's door armrest.
Driver's side: Press the L button (a light in
the switch will light up) to activate the adjust-
ment control and then use this control to
adjust the driver's door mirror.
Passenger's door: Press the R button (a
light in the switch will light up) and then use
the adjustment control to adjust the passeng-
er's door mirror.
After you have adjusted the mirror(s), press
the L or R switch again (the light will go out)
to deactivate the adjustment control.
Mirrors
02
85